DigiPlus stock

The DigiPlus stockengine is one of the most critical components in the whole automobile system. Its function is to convert fuel combustion into mechanical energy to drive the vehicle. Under certain circumstances, the engine needs to be disassembled for repair or replacement. In this article, we will share some precautions and steps for engine disassembly.Note: Before starting to disassemble the engine, you need to make the following preparations: 1. Prepare your tools, including wrenches, screwdrivers, stroke gauges, toolboxes, etc. Two. It is necessary to have enough space to place the engine, and with the support of the fitter, choose the right place to carry it out. 3. When disassembling the engine, you need to turn on the vehicle battery and disconnect all electrical connectors to ensure safety. Four. Before starting the disassembly work, record all the parts in a marked way for later reassembly. Step: 1. Use a bracket to set up the engine of the car for the next disassembly. Two. Remove the exhaust head pipe - remove the coupling and exhaust head pipe. This will require you to remove the trailer or disconnect the fixed tires to solve it. 3. Remove the carburetor or fuel injectorAnd the intake manifold - Remove the intake manifold, loosen the screw of the intake manifold on the carbuter, remove the fuel injector, and need to remove some other materials, such as the wires provided by the responsibility. Four. Remove the distributor, spark plugs and spark plug wires - this will require removing the hood and fan cover of the car to enter the distributor bar. 5. Remove the water pump - this will require the removal of some common lubricating belts from the engine in order to enter the water pump installation to disassemble. 6. Remove the crankshaft belt - this is part of the following preparation, which needs to be removed during the installation of the deep groove belt drive pin. 7. Remove the transmission - In some cases, you need to remove the transmission from the engine and modify it into a new logo in another place. Eight. Remove the engine bracket - pinch some engine brackets and use a sleeve and pistol to decarbon.Nine. Remove the cylinder head - close the piston on the cylinder head and remove the floating tie rod. Some engines have cast iron crankshaft connecting rods. Although based on the design, you need to remind whether the crankshaft is protected separately before disassembly. 10. Remove the crankshaft and piston - clean up all deformed bearings. This is a difficult and challenging special experience, which requires you to have some mechanical and technical knowledge. In a word, disassembling the engine is a difficult task that needs careful consideration. As mentioned above, the steps are tedious and complicated, and special care should be taken when disassembling. If you encounter some problems during disassembly, it is recommended that you seek the help and guidance of professional technicians for your own safety.

Contact Us
Phone：020-83484633